Roberts MessageR Bedienungsanleitung PDF herunterladen (Seite 17)

If you need any further advice, please call our Technical Helpline on :-

020 8758 0338 (Mon-Fri)

Manual tuning - FM

1. Fully extend the wire aerial located on the rear of your radio. Place

the wire antenna so that it is as straight as possible extending either

above or below the radio.

2. Press the On / Off button to switch on your radio.

3. Press and release the DAB / FM button until the FM band is selected.

4. Rotate the Tuning / Select control to tune to a station. The frequency

will change in steps of 50kHz.

If the radio is tuned to a station of sufﬁ cient signal strength with RDS

information present, then the display may change to show the station

name.

5. When the waveband end is reached the radio will recommence tuning

from the opposite waveband end.

6. Set the Volume to the desired setting.

7. To switch off your radio press the On / Off button.

Note:

If you ﬁ nd that FM reception is poor, try repositioning the wire aerial. Fully

extend the wire aerial located on the rear of your radio. Place the wire

antenna so that it is as straight as possible extending either above or

below the radio. If you ﬁ nd that an FM broadcast has a lot of background

hiss, this may often be reduced by setting the radio into Mono reception

mode for the current FM station. Please refer to the section "Stereo / Mono

setting - FM" on page 18 for further details.

2,7

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 39 40

Keine Kommentare

Roberts MessageR Bedienungsanleitung Seite 17